Dedicated Circuit Installation in Spokane, WA

When people call about this

• A new dryer, range, microwave, dishwasher or chest freezer
• A breaker that trips when two appliances run at once
• Power tools or a heater in a garage or workshop
• A home office with computers and equipment on one old circuit

What to ask before you book

Ask whether the panel has space and spare capacity for a new breaker, what wire size and breaker the appliance needs, and whether the route to the appliance means opening finished walls.

Have the property address and a short description ready. Our planning guide has a checklist.

What changes the cost

The appliance and the route decide most of the cost. What moves the price:

• Distance from the panel to the appliance
• Wire gauge and breaker size the appliance requires
• Finished walls or ceilings along the cable route
• Outlet or receptacle type (120V or 240V)
• Permit and inspection fees

Permits and inspections

A new circuit or wiring change is permit work. In Washington, most electrical work needs a permit bought before work starts. When you hire an electrical contractor, the contractor must buy the permit for the job. Depending on the address, permits and inspections are handled by the city or by Washington State Labor & Industries (L&I).

Permit source: Washington L&I: electrical permits and inspections

Typical steps to discuss before booking

1. Call with the appliance, its location and its electrical rating if known.
2. Panel capacity and breaker space are checked.
3. Written scope: cable route, outlet type, breaker and permit.
4. The cable is run, the outlet and breaker installed.
5. The circuit is tested and labeled in the panel.

Keep reading

See panel upgrades if the panel is out of space, hot tub wiring and EV charger installation for bigger 240V loads, and the planning guide.